Just how to upgrade the Jeep Wrangler with led interior light set

In this article, we're mosting likely to be taking a look at a 2019 new LED interior set for the Jeep JK Wrangler. This obtain includes plug-and-play replacements for your dome map and also license plate lights. It's also offered in a variety of color temperatures as well as result levels. it can be mounted at home in your garage with basic hand devices and just takes a couple of minutes. Just that simple.


Initially, we obtain access to the supply map lights. We will go ahead and utilize a plastic tree removal device to take off this plastic cover and also it should stand out off conveniently. Just set that apart, we'll remove our factory light bulbs, simply pull on them a little bit and also they ought to come right out. Next off, we would advise wearing gloves at this point due to the fact that these brightest 194 led bulb light bulbs will fume, you can then plug in your T10 LED replacement bulbs.


Before reinstalling that plastic cover, you can go ahead and also check them for function and after that simply glide that plastic cover right back on.


With our map light finished, we can currently move backwards for the dome light to access your factory dome light.


  • We will use that very same plastic trim removal device to remove this plastic cover press in and below the side and it must come right out.
  • The clear plastic cover does not actually come all the way off for the dome light and also if this black shadow comes off as well don't be distressed.
  • That's absolutely typical, it simply clips back in with four tabs, two on either side to get your manufacturing facility dome light.


You'll merely pull out these little tabs on the bulb and also either side must slide right out. Prior to you put your LED light bulb upgrade in, proceed and also squeeze on these tabs somewhat to make sure that the light bulb is safe and secure and great. Go in advance as well as pop in your led replacement bulb with our interior led bulbs when you pop it in with that done.


After completed, we can go ahead and move on to the license plate. Previously, the setup of your license plate light bulb can not be any type of less complicated. You will pinch 2 tabs on either side of the license plate housing and also turn counterclockwise to release it. After that you'll remove your stock light bulb as well as plug in your T10 LED canbus replacement bulb. This bulb is much better to be non-polar sensitive so we do not require to check the connection. As soon as you make sure that it's connected properly, re-secure the housing, as well as you're performed with your brand-new LED kit set up. You'll currently delight in much better visibility and a great clean modern-day appearance.